Bob Sherer, known as Bob423, has devoted a dedicated chapter in his ICW Cruising Guide to essential insights and practical advice for navigating the Intracoastal Waterway. Covering topics from dinghy protocol to adept boat handling in confined areas, here are his first 8 tips for cruising the ICW.

1. Port and Starboard

When facing forward at the helm, the right side of the boat is the starboard side, and the left side is the port side. Why do boaters use such a "fancy" name for right and left? I was crew on a boat when someone in the cabin asked where the binoculars were stored. The helmsman shouted back, "It's on the left." The crew, facing the helmsman, looked to his left but couldn't find them. After much back and forth, they figured they had better start using starboard and port! Crew on a boat don't always face the same way.

2. Aids TO Navigation (ATONs)

ATONs can be buoys, day beacons, lighthouses – anything used for marking a channel or hazard. ATONs marking a channel will be either red (known as a "nun") or green (known as a "can"). When proceeding south from Norfolk to Key West, you will pass red ATONs on your starboard side with a yellow triangle and green ATONs on your port side with a yellow square. However, there are exceptions when traveling through some rivers where the color rule does not apply, but in those cases, you still pass the ATONs with the yellow triangle on your starboard side and the squares on your port side when headed southward – even if the red and green colors are reversed as they are between the Dismal Swamp and Elizabeth City, Cape Fear River, and other places. The green 19 buoy shown in the picture has a yellow triangle, so it should be honored as a red buoy and passed to starboard when heading southward on the ICW. As in the photo, the yellow markings are not always prominent. I circled the yellow triangle in the photo to point that out. When passing across inlets, look for the yellow squares and triangles to distinguish between ICW ATONs and those marking the inlet channel from the ocean.

3. Always Monitor Channel 16

When underway, continually monitor channel 16. It's monitored by the Coast Guard and used for distress, safety, and for initial contact with another boat or marina unless the marina posts a different channel on its website. The Coast Guard will issue navigation warnings and other alerts over this channel. Most modern VHF radios have a scan function. I scan 16, 13, and 9 at all times. 

4. Slow Down When Being Overtaken by a Faster Boat

ICW courtesy is for the overtaking boat to hail the forward boat at low power on channel 16 or 13 (13 is preferred, but 13 is not always monitored) and ask permission to pass on one side or the other, at which time the overtaken boat replies and slows to idle as the overtaking boat passes slowly by.

After 1000 miles of this, the same maneuver is often shortened to the forward boat noticing the aft boat, which then slows down to idle; the aft boat then passes slowly on the forward boat's port side, all without the use of the VHF (aka Bob423 pass). In our experience, about 95% of passes are silent, and the overtaking boat passes slowly about 90% of the time. If the overtaken boat doesn't slow down to idle, the overtaking boat will often speed by, in our experience.

Tip: after the overtaking boat passes, the overtaken boat should move over across the wake, behind the boat, so when he resumes normal speed, the increased wake that results will not wash over the overtaken boat. Don't forget to wave!

5. Always Ask for a Bridge Opening

Don't let this happen to you! There may be four boats ahead of you, and even though each one asked the bridge attendant for the next opening, you still need to call the attendant and identify yourself. Use channel 13 for bridge requests in Virginia and North Carolina. Use channel 9 in South Carolina, Georgia, and Florida. Call the name of the bridge followed by your vessel's name, request an opening, and await a response. If you get no response, repeat. The bridge tender must know that you want to pass through. Make sure that both sides of a bridge are open – especially if the bridge has two lanes. A boat docked next to us one fall hit the second leaf of a double bridge when it was not apparent it was closed since it was around a curve. In this case, the bridge tender did not announce that part of the second bridge would not open. Stay aware.

6. Dropping the Anchor

Well, you don't just drop the anchor. Pick a spot where you want to anchor and approach it from downwind or current, depending on relative strength. Then, the one at the helm stops the boat, and the one at the bow lays out the chain as the boat is backed. The goal is to lay the chain on the bottom in a line from the anchor (no piling up!), snub it at 70 ft or so, and let it out the rest of the way for the depth, usually 100 to 120 ft. I use a minimum of 5:1 with an oversized anchor and 3/8-inch BBB chain. Then gently back the anchor in, not at high RPMs but enough to be sure the anchor has dug in. In soft mud, an initial hard set may not let the anchor settle into the mud for an eventual good set.

7. Picking up a Mooring or Weighing Anchor

The key to picking up a mooring or anchor is successful communication between the person on the bow who can see where the boat needs to go and the helmsman. For sailboats, there is usually a line of sight between the helmsman and the person at the bow. That may not be the case for a powerboat, and wireless communication headsets may be needed. When weighing the anchor (raising the anchor), you want a vertical pull on the chain for the least strain on the windlass and to rotate the anchor out of the bottom. Use hand signals if the helmsman has a clear line of sight to the bow. They are very simple for us; I point in the direction I want the bow to go. It's up to Ann to figure out how to make the boat go in that direction (ha!). If I want more thrust, I raise my palm; if less thrust, I lower my palm. The approach to picking up a mooring or weighing anchor is always into the wind and/or current, whichever is boss. 

8. Dropping a Mooring

You would think this would be simple: drop the mooring. That part is easy, but now you have to avoid the mooring line, other mooring balls, and moored boats in a crowded mooring field! When I drop the mooring line, I continue standing at the bow and pointing at the mooring ball since Ann, at the helm, can't see it over the bow but now knows where it's at. I keep pointing at the ball until Ann can see it herself. In a busy mooring field, the helmsman is busy monitoring nearby boats or mooring balls that may be empty behind her or to the side and only has to glance towards the bow to know where the ball they just left is located. If the helmsman knows where the mooring ball just dropped is located, then the helmsman can find a path out of the mooring field.

9. Follow the Bends

The current through the ICW will usually cut a deeper path on the outside of curves rather than the inside. It is often tempting to "cut the corners" to take a more direct route between markers, but don't yield to the temptation unless you're in known deep waters. The deeper water is almost always on the outside of a curve in the ICW (never say always).

To read the full chapter and gain more invaluable insight on cruising the Atlantic Intracoastal Waterway, you can find the full ICW Cruising Guide for purchase in the Waterway Guide Mobile App, available for iOS & Android.